Tube 2018 – Düsseldorf, Germany
Meet your business partners at the world’s most important trade fair for the tube and tube processing industry. Business is conducted here; valuable contacts are made and cultivated here; and here you will also see the global innovations that everyone will be talking about tomorrow.
We will demonstrate our high-end digital measuring devices from the Proliner Tracker Industry Series (IS) and our Prodim TubeCheck software. Within the tube industry Proliner Trackers are used most for reversed engineering and quality control on-site and in the factory.
Proliner Trackers – Digital measuring with a wire
Due to the different sizes, radii and angles it is often difficult and time consuming to measure piping systems. Because of the unique technique based on measuring with a wire, measuring tubes with a Proliner Tracker is fast and accurate. The end result is a perfectly calculated digital line drawing of the tube model. LRA data XYZ are instantly available. Measurement data can be exported as CSV or DXF files for further processing, like reversed engineering or production with tube benders. Since the Proliner is portable and all the software is embedded operators only have to carry one device to perform and review all measurements, saving valuable time.
TubeCheck, used for accurate quality control and reverse engineering
TubeCheck is an additional software module for the Proliner Tracker used for the quality control of tubes. With TubeCheck it is possible to compare a measured tube or part of it with master data. Tolerances of intersection points, part lengths angles and rotations can be defined in the master data and uploaded to the Proliner using TubeCheck. After measuring a tube with the Proliner it can be compared with the master data directly. It is immediately clear for the operator if the tube passes or fails the required specifications. As mentioned the Proliner is often used to digitize existing parts for reverse engineering. With the TubeCheck software installed, the Proliner is able to calculate the precise centerline and intersections of complex piping systems.
Fair ground Düsseldorf
Entrances: North, East, South
Stockumer Kirchstraße 61
Hall 05 Stand H09
Date and time
Monday – Thursday (16 – 19 April) – 9:00am – 6:00pm
Friday (20 April) – 9:00am – 4:30pm
More information and show registration
See you at Tube!